Watch this video, then refer to the chart for the properly sized drill, tap and installation tool. Drill with a standard tap drill and countersink with a standard 82° – 100° countersink. Tap the new threads with a standard tap. Screw in the stud end until it is .010-.030 below the surface. Keys locate the proper depth. Drive keys down with several hammer taps on the proper installation tool.
Material: 303 CRES
Finish: Passivated
Tolerances: ±.010 unless specified otherwise
Internal Threads: Per SAE AS8879
Dimensions: All dimensions are in inches
Keys: Integral key inserts are furnished with 2 locking keys.
Material Identification Mark: None
Lubrication: Dry Film Lube on Self-Locking Inserts only
Performance: MIL-I-45914 (NAS1394 and NAS1395).
Material: A286 CRES
Finish: Passivated
Tolerances: ±.010 unless specified otherwise
Internal Threads: Per SAE AS8879
Dimensions: All dimensions are in inches
Keys: Integral key inserts are furnished with 2 locking keys.
Material Identification Mark: None
Lubrication: Dry Film Lube on Self-Locking Inserts only
Performance: MIL-I-45914 (NAS1394 and NAS1395).
Material: 4140 Alloy Steel (160 KSI Min.)
Finish: Cadmium Plate (QQ-P-416 Type II, CI. 2)
Tolerances: ±.010 unless specified otherwise
Internal Threads: Per SAE AS8879
Dimensions: All dimensions are in inches
Keys: Integral key inserts are furnished with 2 locking keys.
Material Identification Mark: None
Lubrication: Dry Film Lube on Self-Locking Inserts only
Performance: MIL-I-45914 (NAS1394 and NAS1395).